How GeoArce calculates solar output and payback
GeoArce is designed to be transparent. This page lists every formula and default assumption used in the calculator. All defaults can be edited in the dashboard.
1. Roof area
You click the corners of a roof to create a polygon. Area is calculated geodesically on the WGS-84 ellipsoid using Turf.js, so it stays accurate at any latitude. Satellite imagery is a top-down view, so a sloped roof's true surface is slightly larger than the traced area. For solar planning the difference is usually small.
2. Usable area and panel count
- Usable area = traced area × usable percentage (default 70%).
- Panel count = floor(usable area ÷ panel area). Default panel area is 1.9 m².
- System size (kW) = panel count × panel wattage ÷ 1000. Default panel is 440 W.
3. Annual energy
Annual energy (kWh) = system size (kW) × peak sun hours per day × 365 × performance ratio × orientation multiplier × tilt multiplier.
- Peak sun hours default: 4.5 per day. Set this to your location; see our country pages or the Global Solar Atlas.
- Performance ratio default: 0.80, covering inverter, wiring, temperature and soiling losses.
- Orientation and tilt multipliers default to 1.0 (ideal).
4. Financials
- Annual savings = annual energy × electricity rate (default 0.16 per kWh in your chosen currency).
- System cost = system size × cost per kW (default 2,600 per kW).
- Simple payback (years) = system cost ÷ annual savings.
The defaults are generic placeholders. For a meaningful result, enter your own tariff and a real installer quote. Incentives and tax credits should be subtracted from cost before you read the payback.
5. CO₂ offset
CO₂ avoided (kg per year) = annual energy × 0.45 kg CO₂/kWh. Equivalent trees = CO₂ offset ÷ 20 kg per tree per year. The grid emission factor varies by country and changes over time, so this is a rough, indicative figure.
6. Limitations
- No detailed shading analysis. Exclude shaded areas when you trace.
- No hourly simulation, battery sizing, tariff structures or degradation modelling.
- Satellite imagery may be out of date.
- Estimates are not a quote, a structural assessment or engineering advice. Always get a professional site survey before installing.
Sources and further reading
- Global Solar Atlas (World Bank / Solargis): globalsolaratlas.info
- NREL PVWatts Calculator: pvwatts.nrel.gov
- Turf.js geospatial library: turfjs.org
Frequently asked questions
How accurate is GeoArce?
It is a planning tool. Area is measured accurately from imagery, but energy and payback depend on the sun hours, losses, tariff and cost you enter. Expect results to be a reasonable first estimate, not a guaranteed yield.
Why is my payback different from an installer's quote?
Installers use detailed shading analysis, local irradiance data, real equipment prices and tariff structures. Replace GeoArce's defaults with your own figures to get closer.
Trace your roof and get your own numbers in under a minute.
Open the free calculator